Digi TransPort LR54, Руководство пользователя

Страница: 574 / 1113

Virtual Private Networks (VPN) L2TPv3 Ethernet
LR54 User Guide 574
n
none : No sequence numbering.
n
send : Add a sequence number to each outgoing packet.
n
recv : Reorder packets if they are received out of order.
n both : Add a sequence number to each outgoing packet, and reorder packets if they are
received out of order.
The default is none .
16. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
17. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access selection
menu . Type quit to disconnect from the device.
Show L2TPV3 tunnel status

Web
1. Log into the LR54 WebUI as a user with Admin access.
2. On the menu, select Status . Under VPN, select L2TPv3 Ethernet .
The L2TPv3 Ethernet page appears.
3. To view configuration details about an L2TPV3 tunnel, click the

(configuration) icon in the
upper right of the tunnel's status pane.

Command line
1. Select the device in Remote Manager and click Actions > Open Console , or log into the LR54
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. To display details about all configured L2TPv3 Ethernet tunnels, type the following at the
prompt:
> show l2tpeth
Tunnel Session Enabled Device Status
----------------- ------- ------------ ------
test/session/test true le_test_test up
>
3. To display details about a specific tunnel:
> show l2tpeth name /vpn/l2tpeth/test/session/test