Digi TransPort LR54-AA401, Руководство пользователя

Страница: 115 / 169

Command descriptions
TransPort LR User Guide 162
ipsec
Configures an IPsec tunnel. Up to 32 IPsec tunnels can be configured.
Syntax
ipsec <1 - 32> <parameter> <value>
Parameters
state
Enables or disables the IPsec tunnel, or enables it as an on-demand interface. The 'on-demand'
setting allows configuring the IPsec tunnel as an on-demand interface. An on-demand interface is
brought up as needed if a higher priority goes down.
Accepted values can be one of off, on or on-demand. The default value is off.
description
A description of this IPsec tunnel.
Accepted value is any string up to 255 characters.
peer
The remote peer for this IPsec tunnel.
Value should be a fully qualified domain name.
local-network
The local network IP address for this IPsec tunnel.
Value should be an IPv4 address.
local-mask
The local network mask for this IPsec tunnel.
Value should be an IPv4 address.
remote-network
The remote network IP address for this IPsec tunnel.
Value should be an IPv4 address.
remote-mask
The remote network mask for this IPsec tunnel.
Value should be an IPv4 address.
esp-authentication
The Encapsulating Security Payload (ESP) authentication type used for the IPsec tunnel.
Accepted values can be multiple values of sha1 and sha256. The default value is sha1.
esp-encryption
ESP encryption type for IPsec tunnel
Accepted values can be multiple values of aes128, aes192 and aes256. The default value is aes128.