Quick Start Guide
Digi One™ IAP, Digi One™ IA, Digi
One™ IAP HAZ
Welcome to your Digi product
Get started:
This guide helps you with initial product setup. Need more? Find additional
supporting material for this product at
www.digi.com/products/serial-servers/digioneiapfamily
.
Or connect to the online documentation by scanning this code:
Digi Technical Support:
Digi offers multiple support plans to help you get the most out of your
product. For information on Technical Support plans and pricing, contact us at 877.912.3444 or
visit
Documentation feedback:
To provide feedback on this documentation, send your comments to
.
1
Verify your components
Included equipment
Verify that you have all included equipment. If any item is missing or damaged, contact your supplier.
2
Set the DIP switch or screw-terminal pins
1. Set the serial DIP switch according to your serial device requirements (EIA-232/422/485). The pinouts are on the back of the device.
Switch settings
*If switch 4 is up, termination resister is connected.
If down, termination resistor is not connected.
DB-9
RS-232
RS-422/485
Full-duplex
RS-485
Half_duplex
Screw term
2
RxD
RxD+
RxD+
6
3
TxD
TxD+
TxD+
3
7
RTS
RTS+
Not used
1
8
CTS
CTS+
Not used
8
5
GND
GND
GND
5
6
DSR
RxD-
RxD-
7
1
DCD
CTS-
Not used
9
4
DTR
RTS-
Not used
2
9
NA
TxD-
TxD-
4
© 2017 Digi International Inc.
Digi, Digi International, and the Digi logo are trademarks or registered trademarks in the United States and other countries worldwide. All other trademarks mentioned in this
document are the property of their respective owners.
