Digi IX20, Руководство пользователя

Страница: 693 / 726

Command line interface Configuration mode
IX20 User Guide 693
3. Save the configuration and apply the change:
(config auth method)> save
Configuration saved.
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access
selection menu . Type quit to disconnect from the device.
n
You can also use a combination of both of these methods:
1. Change to the auth node:
(config)> auth
(config auth)>
2. Enter the revert command with the path set to method :
(config auth)> revert method
(config auth)>
3. Save the configuration and apply the change:
(config auth)> save
Configuration saved.
>
4. Type exit to exit the Admin CLI.
Depending on your device configuration, you may be presented with an Access
selection menu . Type quit to disconnect from the device.
Enter strings in configuration commands
For string parameters, if the string value contains a space, the value must be enclosed in quotation
marks. For example, to assign a descriptive name for the device using the
system command, enter:
(config)> system description "Digi IX20"
Example: Create a new user by using the command line
In this example, you will use the IX20 command line to create a new user, provide a password for the
user, and assign the user to authentication groups.
1. Log into the IX20 command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. At the command line, type config to enter configuration mode:
> config
(config)>