Digi IX20, Руководство пользователя

Страница: 684 / 726

Command line interface Configuration mode
IX20 User Guide 684
Configuration mode
Configuration mode allows you to perform multiple configuration tasks and validate the changes prior
to saving them. You can cancel all changes without saving them at any time. Configuration changes do
not take effect until the configuration is saved.
Enable configuration mode
To enable configuration mode, at the root prompt, enter the config command without any
parameters:
> config
(config)>
When the command line is in configuration mode, the prompt will change to include (config) , to
indicate that you are currently in configuration mode.
Enter configuration commands in configuration mode
There are two ways to enter configuration commands while in configuration mode:
n
Enter the full command string from the config prompt.
For example, to disable the ssh service by entering the full command string at the config
prompt:
(config)> service ssh enable false
(config)>
n
Execute commands by moving through the configuration schema.
For example, to disable the ssh service by moving through the configuration and then
executing the
enable false command:
1. At the config prompt, enter service to move to the service node:
(config)> service
(config service)>
2. Enter ssh to move to the ssh node:
(config service)> ssh
(config service ssh)>
3. Enter enable false to disable the ssh service:
(config service ssh)> enable false
(config service ssh)>
See Move within the configuration schema for more information about moving within the
configuration.
Save changes and exit configuration mode
To save changes that you have made to the configuration while in configuration mode, use save . The
save command automatically validates the configuration changes; the configuration will not be saved
if it is not valid. Note that you can also validate configuration changes at any time while in