Interfaces
Wireless Wide Area Networks (WWANs)
IX14 User Guide
88
5. Delete the target:
(config network interface my_wan> del ipv4 surelink target 1
(config network interface my_wan)>
6. Save the configuration and apply the change:
(config network interface my_wan ipv4 surelink)> save
Configuration saved.
>
7. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Using cellular modems in a Wireless WAN (WWAN)
The IX14 supports one cellular modem, named
Modem
, which is included in a preconfigured Wireless
WAN, also named
Modem
.
The cellular modem can have only one active SIM slot at any one time. For example,
Modem
can have
either SIM1 or SIM2 up at one time.
Typically, you configure SIM1 of the cellular modem as the primary cellular interface, and SIM2 as the
backup cellular interface. In this way, if the IX14 device cannot connect to the network using SIM1, it
automatically fails over to SIM2. IX14 devices automatically use the correct cellular module firmware
for each carrier when switching SIMs.
Configure cellular modem
Configuring the IX14's cellular modem involves configuring the following items:
Required configuration items
n
Enable the cellular modem.
The cellular modem is enabled by default.
n
Determine the SIM slot that will be used when connecting to the cellular network.
n
Configure the maximum number of interfaces that can use the modem.
n
Enable carrier switching, which allows the modem to automatically match the carrier for the
active SIM.
Carrier switching is enabled by default.
n
Configure the access technology.
n
Determine which cellular antennas to use.
Additional configuration items
n
If
Active SIM slot
is set to
Any
, determine the preferred SIM slot.
In the event of a failover to a non-preferred SIM, or if manual SIM switching is used to switch to
a non-preferred SIM, the modem will attempt to reconnect to the SIM in the preferred SIM slot.
To configure the modem:
WebUI
Содержание IX14
