Digi IX10, Руководство пользователя

Страница: 792 / 874

Diagnostics Analyze network traffic
IX10 User Guide 792
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. Type the following at the Admin CLI prompt:
> analyzer stop name capture_filter
>
where capture_filter is the name of a packet capture configuration. See Configure packet
capture for the network analyzer for more information.
To determine available packet capture configurations, use the ? :
> analyzer stop name ?
name: Name of the capture filter to use.
Format:
test_capture
capture_ping
> analyzer stop name
Show captured traffic data
To view captured data traffic, use the show analyzer command. The command output show the
following information for each packet:
n
The packet number.
n
The timestamp for when the packet was captured.
n The length of the packet and the amount of data captured.
n
Whether the packet was sent or received by the device.
n
The interface on which the packet was sent or received.
n
A hexadecimal dump of the packet of up to 256 bytes.
n
Decoded information of the packet.
To show captured data traffic:

Command line
1. Select the device in Remote Manager and click Actions > Open Console , or log into the IX10
local command line as a user with full Admin access rights.
Depending on your device configuration, you may be presented with an Access selection
menu . Type admin to access the Admin CLI.
2. Type the following at the Admin CLI prompt:
> show analyzer name capture_filter
Packet 1 : May-05-2022 9:03:04.287682, Length 60 bytes (Captured Length
60 bytes)
Received on interface eth1