Overview
Direct port access
Digi CM User Guide
17
Direct port access
Connect directly to a properly configured port through a Telnet or SSH session. Configuration
requirements include setting the Host Mode to Console Server Mode and the Protocol to either
Telnet or SSH. Ports, by default are set to Console Server Mode and Telnet. Use the following
information to make a Telnet or SSH connection to a port:
Note
The example assumes that the Listening TCP port is 7003, the default for port 3.
Custom menus
Custom menus are created by either root or the system administrator to limit your access to specific
ports. For more information, see
.
Port escape menu
Port escape is the ability to escape from a port without disconnecting. Port escape is available in
main sessions as well as sniff sessions. Every connection method accommodates port escape. You
configure the escape sequence per port. Follow the procedure to configure the port escape
sequence.
1 Serial Port
>
Configuration
> Select the port number or All.
2 Host mode configuration
> Port escape sequence - enter a letter for the Port escape sequence.
3
Click
Save to flash
and continue with other configurations or click
Save & apply
for the changes
to take effect.
Type
Command syntax
Example: connection to port 3
Telnet telnet
ip-address
tcp-port
where
ip-address
is the Digi CM unit’s IP
address and
tcp-port
is the Listening TCP port
for a port
telnet 192.168.15.7 7003
(7000 is the default socket port for both Telnet and
SSH)
SSH
ssh
user-name@
ip-address
tcp-port
where
user-name
is a user’s name,
ip-address
is the Digi CM unit’s IP address and
tcp-port
is the Listening TCP port for a port
ssh admin@ 192.168.15.7 -p 7003
(7000 is the default socket port for both Telnet and
SSH)
http://
digicm.digi.comconnect.asp?t=CISCO.Router.port3
Содержание Digi CM 16
