Configure and manage the device using the Digi ConnectPort X Family command line interface
Administration
Digi ConnectPort X Family
225
status
Use the
status
command to display a list of sessions or outgoing connections made by the
connect
,
rlogin
, or
telnet
commands for a Digi device. Use the
status
command to determine which of the
current sessions to close.
show
Use the
show
commands to display current settings on a Digi device.
telnet
Use the
telnet
command to establish an outgoing telnet connection, also known as a session.
vpn
Use the
vpn
command to manage Virtual Private Network (VPN) connections.
xbee
The
xbee
command executes an XBee utility or displays the status of actions performed by the XBee
utilities. Actions include displaying information about the XBee network setup, sending loopback data,
displaying the status of XBee firmware, and scheduling XBee firmware updates.
who and kill
Use the
who
command to display a global list of connections. The list of connections includes those
associated with a serial port or the command-line interface.
Use the
kill
command to terminate active connections based on the ID number returned from the
who results.
Use the
who
command to determine any connections that are no longer needed, and end the
connections by issuing a
kill
command.
Administration
You can issue commands from the command-line interface to administer Digi ConnectPort X Family
products. The following table displays several administration tasks and the commands used to
perform them. See the
Digi Connect® Family Command Reference
for more complete command
descriptions.
Administrative task
Command
Backup/restore a configuration from a
TFTP server on the network
backup
