Digi ConnectPort LTS 16, Справочник по командам

Страница: 159 / 169

Command descriptions set xbee
ConnectPort® LTS Command Reference 159
set xbee
Purpose
The “set xbee” command performs several functions:
n
Displays current configuration settings for the XBee RF module
n
Displays Xbee settings for a particular node
n
Changes the state of the XBee RF module (enabled/disabled)
n
Loads firmware to the XBee RF module
n
Executes AT commands on the XBee RF module
The XBee RF module is regarded as one of the serial ports on the ConnectPort LTS device. To
configure other non-XBee settings for access to the XBee RF module, please see the commands
related with serial ports, such as
"set serial", "set tcpserial", "set udpserial", "set portauth", “set service" and "set autoconnect."
Required permissions
Permissions must be set to one of the following:
n
For a user to display the Xbee settings: “set permissions s-xbee=read”
n
For a user to display and set the Xbee settings: “set permissions s-xbee=rw”
Syntax
Display current configuration settings for the XBee RF module
set xbee
Display Xbee settings for a particular node
set xbee address={
id|address}
Change XBee RF module state
set xbee state={on|off}
Load firmware to the XBee RF module
set xbee load={host:
filename}
Execute an AT command on the XBee RF module
set xbee <CC>[[=]
param]
Options
state={on|off}