Digi ConnectPort LTS 16, Справочник по командам

Страница: 143 / 169

Command descriptions set trace
ConnectPort® LTS Command Reference 143
set trace
Purpose
Configures a ConnectPort LTS product for tracing and displays tracing information.
Tip The “set trace” command should be used when working with Digi Technical Support. Enabling
tracing can have an impact on system performance. Digi provides no guarantee that trace output is
the same across firmware revisions.
Required permissions
For Digi products with two or more users, permissions must be set to “set permissions s-trace=read”
to display tracing information, and to “set permissions s-trace=rw” to display tracing information and
configure trace options. See “set permissions” for details on setting user permissions for commands.
Syntax
Display latest command options
The syntax and available options for “set trace” may vary by product and product release. Enter the
following command to view the current list of options:
help set trace
Configure trace options
set trace [state={off|on|dump}]
[mode={historical|concurrent}]
[syslog={on|off}
[loghost=
ip address]
[mask= type:severity]
Display tracing information
set trace
Options
state={off|on|dump}
Sets the state of the tracing function.
off
Turns the tracing function off.
on
Turns the tracing function on.
dump
Displays historical trace messages, when “mode” is set to “historical.”