Serial port
Configure Modbus mode
Digi Connect EZ Mini User Guide
107
19. (Optional) Enter a string that should be added at the beginning of each packet:
(config)> serial port1 udp socketid
backslash-escaped-string
(config)>
20. Configure the remote sites to which you want to send data. If you do not specify any
destinations, the Connect EZ send new data to the last hostname and port from which data
was received. To add a destination:
i. Add a destination:
(config)> add serial port1 upd destination end
(config serial port1 udp destination 0)>
ii. (Optional) Enter a description of the destination:
(config serial port1 udp destination 0)> description
string
(config serial port1 udp destination 0)>
iii. Set the host name or IP address of the remote site to which data should be sent:
(config serial port1 udp destination 0)>hostname
hostanme-or-IP-
address
(config serial port1 udp destination 0)>
iv. Set the port number of the remote site to which data should be sent:
(config serial port1 udp destination 0)> port
port
(config serial port1 udp destination 0)>
21. Save the configuration and apply the change:
(config)> save
Configuration saved.
>
22. Type
exit
to exit the Admin CLI.
Depending on your device configuration, you may be presented with an
Access selection
menu
. Type
quit
to disconnect from the device.
Configure Modbus mode
Modbus
mode allows you to use the serial port for Modbus. See
To change the configuration to match the serial configuration of the device to which you want to
connect:
WebUI
