Digi AnywhereUSB Plus, Руководство пользователя, Страница: 772 / 815

Configure the AnywhereUSB Manager from the command line list full
AnywhereUSB® Plus User Guide 772
list full
Purpose
Displays a list of all Hubs, groups, and devices on the network and includes all information about each
Hub, group, or device. This command displays the same information retrieved by running these
commands:
list , hub info , group info , and device info .
If a group has auto connect enabled, an asterisk displays next to the group name.
Additional information about features displays at the bottom of the list:
n
Status of the auto-find feature: enabled or disabled.
n Status of the auto connect all feature: enabled or disabled.
n
Specifies whether the AnywhereUSB Manager is running as a service .
Syntax
>awusbmanager list full
Examples
Run the
list full
command.
>awusbmanager list full
The example below shows the Hub on the network, and the groups and devices on that Hub.
Information about the Hub, group, and device is also returned.
AnywhereUSB Manager, below are the available devices:
AW08-D00001 (10.10.12.12:18574)
NAME: AW08-D00001
MODEL: AnywhereUSB 8 Plus
VERSION: 3.0.1.2 awusb
STATE: Active (secure)
ADDRESS: 10.10.12.12
PORT: 18574
CONNECTED FOR: 14 sec
CONNECTION ID: 3
INTERFACE: eth0
SERIAL NUMBER: AW08-D00001
AUTOCONNECT: disabled
Group 2 (AW08-D00001.2)
ADDRESS: AW08-D00001.2
GROUP: 2
NAME: Group
2
PORTS: 5 6 7 8
AUTOCONNECT: disabled
IN USE BY: NO ONE
Cruzer (AW08-D00001.1906)
ADDRESS: AW08-D00001.1906