5
VHX
DOS 1.71 OWNER’S MANUAL.
© 2020 Diezel GmbH. All rights reserved.
d
FRONT PANEL
1 INPUT
Connect your guitar he
re trough a good quality ¼”
Instrument cable.
2 PRE LOOP SEND
Pre Loop SEND (output). Connect here the input
of one or a chain of effects. PRE LOOP is internally wired before the
PREAMP.
3 PRE LOOP RETURN
Pre Loop RETURN (input). Connect here the
output of the same effects used form PRE LOOP SEND. PRE LOOP is
internally wired before the preamp.
4 PRESET MANAGER
Rotate
the encoder to scroll between all the
available presets, from 1 to 99.
Push
to open
Preset Manager
.
5 ENCODERS
This group of encoders will let you edit, by
rotating
,
pressing
, or
holding
the relative function shown on DISPLAY. Follow
the lines.
6 DISPLAY
This is the Display where all the parameters will be
visualized. Each encoder will control the respective parameter on
display, follow the lines.
7 SCREEN MANAGER / MUTE
Rotate
the encoder to scroll between
all the available screens.
Push
the encoder to
MUTE
or
UNMUTE
the
POWER AMP so connected cabinets. POWER AMP cannot be
UNMUTED if no cabinet is connected.
8 MASTER VOLUME
This is the POWER AMP Master Volume, it only
affects POWER AMP so connected cabinets.
9 STANDBY SWITCH
Make sure the switch is on STANDBY mode
before powering on the VHX. Let the tube warm up for at least 40
seconds.
10 POWER SWITCH
Make sure STANDBY is set to OFF before
powering ON the VHX. Before powering OFF the VHX set STANDBY
switch OFF and wait at least 30 second to avoid POWER AMP bump.