7
INSTALLING THE DOCKING STATION
Set up the
Docking Station
to work with your PC as
follows:
1. Shut down the PC.
2. Connect the female end of the 25-pin Docking
Station cable to the “Parallel” connector at the rear
of the
Docking Station
as shown below.
3. If you are using a local printer that is attached
directly to your PC, and the PC only has one parallel
port (LPT1) shut down the printer and the printer
software, then disconnect it from the parallel port.
4. If you are using a local printer, and your PC
has more than one parallel port, connect the
Docking Station cable to an available
parallel port.
5. Connect the male end of the 25-pin Docking Station
cable to the parallel port on your PC (Figure 1 on
page 8).
Note
:
The Docking Station should be the
only device connected to the port.
6. Connect the smaller end of the AC adapter to the
connector labeled “Power” at the rear of the
Docking Station
as shown in Figure 2 on page 9.
7. To power up the
Docking Station
, connect the
electrical plug on the AC adapter to an outlet or
power strip.
Install
ing the Docking
S
tation
L-2475-000.book Page 7 Wednesday, February 23, 2000 9:38 AM
