Op
erator’s manual
version: 2021.06
23
4.5
I
NSTALLATION OF THE MEMBRANE
1.
Disconnect the water inlet pipe from the membrane holder (Figure 1).
2.
Remove the membrane holder out of its two plastic stirrups (Figure 2).
3.
Unscrew (by turning to the right) the cap of the membrane holder using the two special keys provided
with the accessories (Figure 3).
4.
Once the membrane cap is removed, insert the new membrane by introducing first the side with 4
seals, press the membrane to completely insert it in the membrane holder (Figure 4).
figure1
figure 2
figure 3
figure 4
5.
Check that the O-ring on the top of the membrane holder is properly placed.
6.
Screw (by turning to the left) the cap of the membrane holder using the two special keys provided.
7.
Place the membrane holder on its stirrups.
8.
Reconnect the water inlet pipe to the membrane holder (Figure 1).