Diamond Products CPG200, Руководство оператора

Страница: 24 / 36

MAINTENANCE
Daily Service
For the following daily service items please
refer to the motor or engine manuals and
the specific manufacturers for a full motor
or engine maintenance schedules and
additional motor or engine maintenance
information
.
•
Check Engine Oil Level
•
Check Engine Fuel Level
•
Check the Air Filter
Handlebar
The handlebar generally requires little or no
maintenance and, when used correctly, should
remain in good, working condition. Inspect the
handlebar occasionally for bending, unusual
cracks, and/or breakage. Replace it
immediately when damaged.
Lubricate the Blade Shaft and Gear
Shaft Bearings
WARNING
DO NOT grease parts with the
motor running.
Lubricating the blade shaft and gear shaft
bearings on schedule increases the floor
grinder’s efficiency and life. Use NLGI No. 1
premium lithium-based grease when
lubricating parts. Use one-half to one full pump
of grease when lubricating grease fittings.
At the end of each work day, lubricate the two
blade shaft bearings and one gear shaft
bearing. All three bearings and their respective
grease fittings are located on the top of the
head plate assembly.
1. To access the gear shaft bearing’s grease
fitting, remove the six 5/16”-18 hex head
bolts from the weight box.
2. Remove the weight box.
Weight Box Bolts
(Three per side)
3. Add no more than one pump of bearing
grease into the blade shaft and gear shaft
bearings grease fittings.
Blade Shaft and Gear Shaft Bearing Grease Fittings
4. When the bearings have been greased,
reinstall the weight box and secure with the
six 5/16”-18 hex head bolts.
Inspect the Drive Belts
Inspect the drive belts after the first four hours
of use and then daily for tension or wear. Re-
tension or replace as required.
Drive Belt Access
1. Remove the six 5/16”-18 hex head bolts
from the weight box.
2. Remove the weight box.
Weight Box Bolts
(Three per side)
24