Diamond Audio MICRO8 Series, Руководство пользователя

Страница: 11 / 20

TURN-ON OPTIONS
- configure the “Turn-On Mode” switch for desired turn-on trigger. There are 3 modes available
on the MICRO series amplifier, REM, DC and VOX. (REM) is the standard 12V trigger wire (DC) or DC offset (when
connected high level in, this will sense differences in ground in your wiring through the speaker leads and turn on amplifier),
VOX (signal sensing) will sense any kind of signal input into the amplifier RCA turning on the amplifier. The most preferred
and reliable method is using the REM setting with a 12V trigger wire connected to the vehicles headunit switch ouput and
will provide instant on and off for the amplifier. VOX and DC will provide turn on capabilities for the amplifier when a 12V
trigger wire is not available. These methods will have some delay in turning the amplifier on and off.
OPTIONAL SOURCE - BLUETOOTH RECEIVER (BTR9/10/12) SETUP
The BTR will pair to your phone (or any selected Bluetooth device) and will allow playback through the amplifier to
speakers giving you unlimited install options. The DAT line of BTR’s have 7 functions - Play, Pause, Volume up/down,
Track up/down, Pairing and Power on/off of Bluetooth audio through this one solution. Once paired, the BTR will auto
pair the last person paired to the controller when it was powered down. The unit will remember up to 9 users and have
memory without battery for up to 30 days.
11
SYSTEM CONFIGURATIONS
BRIDGING STEREO/4 CHANNEL AMPS
MICRO81U SIGNAL ENDPLATE
MICRO81U POWER/SPEAKER ENDPLATE
SPEAKER
OUTPUT
INPUT SIGNAL
HARNESS
MICRO82U SIGNAL ENDPLATE
MICRO82U POWER/SPEAKER ENDPLATE
INPUT SIGNAL
HARNESS
SPEAKER OUTPUT
HARNESS
Since the MICRO8 series amplifiers can take speaker
level in the easiest and cleanest way to connect to your
radios speaker outputs is to buy some stereo RCA
cable and just strip the wires to connect to
the OEM amplifier/Headunits speaker outputs
then plug directly into the amplifiers RCA input
harness. Just switch how Turn-On works
(REM/DC/VOX)
SPEAKER LEVEL INPUT (OPTIONAL):
USE THE LEFT + AND THE RIGHT -
MICRO81U - MONOBLOCK
SUBWOOFER(s)
STEREO FULL-RANGE
SPEAKERS - 2 PAIR
IN PARALLEL (2 OHMS)
MICRO82U- STEREO 2 OHMS
W/ 4 SPEAKERS
HEAD UNIT
(PERFERREDLY 5V OUTPUT)
HEAD UNIT
(PERFERREDLY 5V OUTPUT)
BATTERY
BATTERY
SUB PRE OUTPUT
FROM HEAD UNIT
SUBWOOFER
Want a REALLY BIG 2 channel amplifer? Then BRIDGE
a 4 channel amp! Easiest way is to use “Y-Adaptors”
These are readily available pretty much anywhere and
makes “bridging“ easy. Use a Y-Adaptor on the FRONT
input (L/R) - this will now be LEFT. Do the same on the
rear (L/R) - this is now RIGHT. Connect the speakers
to the BRIDGED connection on the amplifier (FRONT is
now LEFT/RIGHT is now REAR) and your DONE!
NOTE: you MUST connect ONLY a 4 ohm load!!!