4
SAFETY INSTRUcTIONS
Please test inconspicuous parts of all surfaces and objects to ensure colour-fastness
and heat resistance. We will not be liable for damage caused by failure to test the
surfaces to be cleaned.
1) Never open the filler cap while the boiler is under pressure. Release the pressure using
the steam button on the pistol grip only.
2) Do not add detergents or other additives. Use only mains water – no distilled water.
2) Take care to ensure that the electrical data on the type plate corresponds to the local net-
work voltage.
4) Never dip the device in the water.
5) Pull the mains plug when the device is not in use or is to be left unattended, or when fil-
ling the tank or cleaning the device.
6) You must only use the DIAMANT for the applications described in these instructions.
7) Use only original replacement and accessory parts.
8) Do not pull the mains plug out of the socket by the cable.
9) Do not allow the mains cable to come into contact with hot surfaces.
10) The steam generated by the device can reach very high temperatures (150°C) upon lea-
ving the device. Avoid all contact with the steam. Do not point the steam spray at per-
sons or animals.
11) This device is not a toy. Special care is required when used by children or in the vicinity
of children.
12) Never use steam to clean electrical devices, such as radios, televisions or other hou-
sehold appliances generally.
13) When using the electric iron, take care to ensure that the iron is safely stowed at all
times (for example, the support base on the table).
14) Only put the DIAMANT away after it has completely cooled off. The tank need not be
emptied unless the device is to remain unused for a long time.
15) Do not use the device if it has been damaged or if the mains cable or any of the acces-
sory parts is damaged. Inspections and repairs of all kinds must always be performed
by our client service department. Unauthorised repair work may be dangerous and will
void the warranty.
11
Electric steam iron
(optional)
25. Steam button for continuous steam
26. Steam button for puffer
27. Cork handle
28. Connection hose
29. Stainless steel iron base
30. Temperature regulator
25
26
27
28
30
29
FILLING THE BOILER
If the steam of the DIAMANT finishes while using the machine, the “water level” warning
light lights up. The boiler must then be refilled with water.
Proceed as follows:
1c. Leave steam switch (3) on
2c. Turn off the main switch 4.
3c. Operate steam trigger (G1) on handle (18) or the steam button on the iron till the steam
runs out.
4c. Disconnect supply plug from the mains (9).
5c. Unscrew safety plug (1) turning it in an anticlockwise direction.
6c. Wait for a few minutes to let the boiler cool down.
7c. Fill the machine as described in the GETTING STARTED chapter. If filling the tank
when hot, add small quantities of water in order to prevent water from evaporating straight
away. To fill the tank use dosing bottle (21).
8c. Close the machine and plug it in again, switch the general switch on and wait for “pres-
sure” light (6) to light up.
9c. The DIAMANT is ready for use again!
FINISHING USING THE MAcHINE
• Switch boiler switch (4) off
• Vent the remaining steam using steam button (G1) or iron (25).
• Unplug supply cable from the mains (9).
• Let the machine cool down before putting it away.
• Tips
Wool: only steam, without pulling the fabric
Silk: dampen and then only steam
Velvet: iron inside out with a little steam or steam only without turning inside out
