Dialogue Flybook V5W1BB, Руководство пользователя

Страница: 68 / 83

Tips for troubleshooting — 59
Troubleshooting and specifications
Tips for troubleshooting
In each problem-specific section, try the steps in the order suggested. This may
help you to solve the problem more quickly.
Try to pin point the problem and thus avoid replacing non-defective parts.
Keep a record of the steps you take when troubleshooting: The information
may be useful when calling for technical support or for passing on to service
personnel.
Identifying problems
Follow the steps below to identify your problems:
1. Turn off the computer.
2. Disconnect any peripheral devices such as an external mouse or printer.
3. Make sure that the AC adapter is properly connected to your computer and
the power source is good. (Use some other electrical device to confirm that
the electrical outlet is working.)
4. Leave the computer off for approximately 10 seconds, and then switch it on
again. The computer should enter the boot sequence and start normally.
5. If the computer does not start normally, look for a screen message or other
clue on the malfunction.
If failure is detected in an area other than the mainboard, an error message is
displayed on the screen and testing is stopped.
If your system does not successfully start, but displays a blank screen, emits a
series of beeps, or displays an error code, consult your dealer.
General hardware problems
A few common hardware problems and suggested solutions are presented
below: