Dialogic 1000Series, Руководство пользователя, Страница: 302 / 326

302 Dialogic
®
1000 and 2000 Media Gateway Series User’s Guide
Diagnostics
9.5.2 Connecting to Terminal Interface Via LAN Connector
Perform the following to initiate a Telnet session at the workstation connected to the Media
Gateway via the LAN interface:
1. From the command prompt, type telnet followed by a space and the IP address of the Media
Gateway. Then press Enter.
2. The telnet client connected message will appear. Press Enter. The following prompt will
appear:
PIMG>
3. At the prompt, type pwd and then press Enter.
4. When prompted, enter the password for the Admin user (the default is IpodAdmin ) and press
Enter.
The Media Gateway will respond with Admin level accepted , and then display the prompt.
You may now issue terminal commands to the Media Gateway.
9.6 Trace Mechanism
The trace mechanism has been designed to provide the maximum flexibility in tracing the various
modules of the Media Gateway software. The trace utility is supported by the serial port terminal as
well as the telnet terminal, and is available to users at Admin levels and above. Therefore, to enable
the trace utility, the user must log on to the terminal using a valid password.
Note: The trace mechanism can be accessed via the Trace Capture interface as described in Section 9.4.2,
“Trace Capture” , on page 294.
Information in this section includes:
• Trace Format
• Trace Utility
• Trace Commands
• Examples of Trace Commands and Displays
The trace function allows the user to enable or disable different types of traces in different software
modules. It also allows the user to enable or disable traces that are related to the telephony ports on
the Media Gateway. Therefore, control of telephony port traces is separate from the control of
traces of the various software modules. This allows the user to set the trace control of the modules
as desired, and then separately set the telephony ports that are needed to be traced.
Traces that are related to a telephony port number are tagged with the 1-based telephony port
number to which they are related. For instance:
Telephony port 1 events:
002:53:542 [Tel-1 ] Event Lamp 60:CallApp0:0 OFF->FLASH
002:53:782 [Tel-1 ] Event 0:0:48| 250 |
002:53:784 [Tel-1 ] Event Cpid (250->) (Direct)