DI Lusso R6, Инструкция по установке и эксплуатации

Страница: 15 / 24

12
R
E
-
ASSEMBLING THE STOVE
1. Smear a bead of fire cement around
the flue hole on the outside of the
firebox.
2. Offer the firebox into position and
slide it back as far as possible.
3. Refit the fixing screws through the
firebox legs. Tighten the screws
equally to draw the firebox into place.
Do not over-tighten!
4. Refit the two M8 x 25mm studs into
the two fixing holes around the flue
outlet. Fix in place with the washers
and nuts.
5. Wipe off any excess fire cement
around the inside of the flue which
may have been squeezed out when
fitting the firebox.
6. Refit the fire bricks and log retainer.
7. Check that the valves are in the fully
open position (fully clockwise) and
refit the Air Valve Cassette.
8. Close the stove door and check that
the touch latch pin is in line with the
touch latch in the control fascia.
9. Refit the two fixing screws through
the holes in the Air valve cassette
fascia.
10. Unpack the Flue Baffle and identify
the two halves –
11. Stack the two baffle halves with the
right hand baffle sat on top of the left
hand baffle as shown –
12. Lift the two baffles up together inside
the firebox to the right hand side of
the baffle support bracket, slide the
baffles to the left and rest them on
the support bracket at the front of the
stove and the Tertiary Air Bar.
Left Hand Baffle
Right Hand Baffle
Fire Cement
Wipe off excess
fire cement