DLEV1
Operating Instructions
- 10 -
2 Safety Notes
This DLEV1 is fully compliant with the requirements of:
BS EN 61010-1
BS EN 61010-2-30
In order to ensure the safe operation of this adaptor, all notes and
warnings in these instructions must be observed at all times.
The DLEV1 has been designed to make measurements in
a dry environment.
The DLEV1 may be used to test circuits with a maximum
over-voltage Category II, 300 V AC/DC with reference to
earth.
The d
anger
of electric shock is present when PE Pre-Test
indicator lights while performing PE Pre-test. in this case,
further testing must be stopped immediately, ensure a
s
ufficient
connection of your body to earth while
performing this test.
The DLEV1 and all associated cables and leads must be
checked for signs of damage before t
he
equipment is
operated.
Terminals with low voltage CP Signal output (Approx.
±12V) powered by the charging station, when the terminal
marked with "
” is connected to PE, use for test
purposes only and in the case of incorrect wiring or error
of the charging station, these terminals may present a
hazard.
Where the safe operation of the DLEV1 is no longer possible, it should
be immediately shut down and secured to prevent accidental operation.
It must be assumed that safe operation is no longer possible:
- if the instrument or leads show visible signs of damage or
- the instrument does not function or
- after long periods of storage under adverse environmental conditions.
If the DLEV1 is used in a manner not specified by this
document, then the protection provided by the equipment
may be impaired.