Safety Information
Safety Information
Check the test leads for damaged insulation or
expose metal. Check the leads for continuity. Replace
damaged leads with identical model or specification
before using the meter.
Where applicable use GS38 approved leads (not
supplied) these are available from Di-Log. When using
test leads keep fingers behind the finger guards.
Do not apply more than the rated voltage, as marked
on the meter between the terminals or between any
terminal and ground.
Before making a measurement ensure that the rotary
switch is set to the appropriate range. Do not turn the
rotary switch whilst making a measurement.
Use the appropriate terminals, function and range for
your measurements. If the value to be measured is
not known use the maximum measurement position
and reduce the range step by step until a satisfactory
reading is obtained.
Do not use or store the meter in an environment
of high temperature, humidity, fumes, vapour,
gaseous, inflammable and strong magnetic field.
The performance and safety of the use may be
compromised in such circumstances.
Disconnect circuit power and discharge all high
voltage capacitors before testing resistance,
continuity, diodes, capacitance or current.
