Dhollandia DH-S Series, Руководство по установке

Страница: 22 / 82

21
DHOLLANDIA
•
Once the position of the fitting jig is finalized and checked, fasten them to the rear cross member of the loading floor of the
vehicle by means of bolts, clamps, or spot welding. [Figure 8.4]
•
Ensure that the center holes of the 2 fitting jigs are perfectly aligned. One way to accomplish this is to slide a round bar through
the holes and to check the alignment with the rear cross member of the loading floor.
8.2 METHOD WITH HORIZONTAL PLATFORM
•
This is recommended for the slider liftgate with a flat platform
(DH-
SK…) and for all situations where the fixation of the fitting
jigs to the rear cross member of the vehicle floor is problematic.
•
Determine the distance (if any) at which the platform should stop
behind the rear cross member of the loading floor. Prepare a
corresponding spacer to insert between the rear cross member
and the platform during fitting.
•
Mount 2 strong tubes over the front edge of the platform.
[Figure 8.5]
•
Position the platform with the 2 tubes attached to it on the loading
floor of the vehicle. Slide the required spacer (if any) between the
rear cross member of the vehicle floor and the platform [Figure
8.6], and secure the platform safely (by means of a hoist,
overhead gantry crane, or from underneath by a forklift of lifting
jack…). [Figure 8.7]
•
Center the platform and check that is it parallel with the rear cross
member of the loading floor.
•
Note: there will be a gap between the rear cross member of the
loading flor and the platform in horizontal work position. This will
need to be covered by a bridge plate during operation.
•
This fitting method (with gap between the platform and loading
floor) can only be used if the platform can be stopped at the
loading floor by other means than the standard stops which are
fitted to the front side of the platform. See also section 9.3
regarding arm stops.
Figure 8.4
Figure 8.5
Figure 8.6
Figure 8.7