Dhollandia DH-CH003, Руководство по установке

Страница: 52 / 59

51
DHOLLANDIA
9.2 PRESCRIBED TORQUE VALUES FOR BOLTS SUPPLIED WITH WHEELCHAIR LIFT

The installer MUST verify that all bolted connections are fastened with required torque in accordance with the table below.

After weight testing, the installer MUST verify that all bolted connections between lift frame and mounting plates, and between
mounting plates and vehicle chassis are still tightened in accordance with required torque. Retighten if required.

Use a calibrated torque wrench to tighten bolts and nuts to the prescribed torque value.
NOTICE
WARNING

Incorrect, too soft or too hard tightening of bolts can lead to accidental fall of the tail lift off the vehicle chassis.

A fall of the tail lift off the chassis can damage the tail lift and / or vehicle chassis and can cause serious bodily injury or death
to the operator and any bystanders.

Therefore, it is essential that the mounting plates are installed following the instructions of this manual.
Banjo Bolt Torque Specifications
BSPP
Banjo
Bolt
Size
Newton
Metre
(Nm)
Pounds
Force - Feet
(lbsf-ft)
Metric
Banjo
Bolt
Size
Newton
Metre
(Nm)
Pounds
Force -
Feet (lbsf-
ft)
1/8 17 12 M10 10.5 13
1/4 34 25 M12 24.5 15
3/8 47 35 M14 48 19
1/2 102 75 M16 85 33
5/8 122 90 M18 136.5 37
3/4 149 110 M20 195 52
M22 136 55
M26 195 81