Dhollandia DH-AI02.04.01, Руководство по установке

Страница: 43 / 45

42
DHOLLANDIA
11.2 PRESCRIBED TORQUE VALUES FOR BOLTS AND NUTS

The installer MUST verify that all bolted connections are fastened with required torque in accordance with the table below.

After weight testing, the installer MUST verify that all bolted connections between ramp frame and mounting plates, and between
mounting plates and vehicle chassis are still tightened in accordance with required torque. Retighten if required.

Use a calibrated torque wrench to tighten bolts and nuts to the prescribed torque value.
NOTICE
WARNING

Incorrect, too soft or too hard tightening of bolts can lead to accidental fall of the ramp off the vehicle chassis.

A fall of the ramp off the chassis can damage the ramp and / or vehicle chassis and can cause serious bodily injury or death to
the operator and any bystanders.

Therefore, it is essential that the mounting plates are installed following the instructions of this manual.