23
DHOLLANDIA
WARNING
ALWAYS use tire adaptors when required and secure them on the lift forks. Negligence to use tire adaptors or to secure the
tire adaptors on the lift forks by means of the locking latch, may cause the vehicle to become instable and tilt over. Failure to
abide by these instructions can result in serious bodily injury or death to the operator or bystanders.
Furthermore, failure to abide by these instructions can result in property damage to the vehicle and / or the mobile column lift.
9.5
CONNECTION OF THE MASTER AND SLAVE COLUMN
The master and slave column of one single mobile column lift are interconnected via a wire and hose loom between both
columns, by means of an electrical plug and a hydraulic quick-snap coupling.
To make the electrical connection between the master and slave cylinder, insert the male plug at the end of the lose cable
into the female socket mounted in lowest position on the electric control box on the master column. Align the plug straight in
front of the socket, push it in gently, then turn the outer ring clockwise to secure the connection. (Proceed in opposite sequence
to disconnect.)
To make the hydraulic connection between the master and slave cylinder, insert the female coupling on the lose hydraulic
hose onto the male coupling premounted just below the hydraulic power pack on the master column. Pull the coupling to verify
it is properly fastened.
