DGSHAPE DWX-4, Руководство пользователя

Страница: 16 / 53

16
Chapter 2 Cutting
How to Use / Read the Built-in Panel
How to Use / Read the Built-in Panel
ERROR
Flashes when an error has occurred.
PAUSE
Lights while the operation is paused.
CANCEL
Flashes while the data is canceled or the initial operation is performed.
The cutting data received while the lamp is flashing is canceled.
Operation button
Press this button to operate, suspend, or restart the machine.
Holding down this button will stop cutting.
The button lights up when the power is turned on and flashes when the machine
is in operation.
Colors and Statuses of Signal LED Lamp and Operation Button
Blue
The machine is in the standby status or executing initialization.
The shaft will rotate 180º when the operation button is pressed in the standby
status. If the tool is mounted, it is returned to the ATC magazine. A lapse of 5 min-
utes without any operation during standby causes the signal LED lamp to be turned off.
White
Cutting is performed or suspended, or the front cover is open.
Cutting will be suspended when the operation button is pressed. Cutting can be
resumed by pressing the button again. Holding down the operation button will stop cutting.
Yellow
An error occurred, and cutting is suspended.
Check details of the error displayed on the screen of VPanel. Cutting can be
resumed by pressing the operation button.
Red
An error occurred, and cutting is suspended and cannot be resumed.
Check details of the error displayed on the screen of VPanel. When the LED is
lit, the machine will stop cutting and return to the standby status by holding
the operation button depressed. When the LED is flickering, turn off the power,
and turn it on again to restart the machine.
ERROR
PAUSE
CANCEL
ERROR
PAUSE
CANCEL
Operation
button
Signal LED Lamp