DFSK Seres 3 2019, Руководство пользователя, Страница: 201 / 233

Instructions for Use of EV Charging Plug
- 200 -
Environment Requirements
for Use of Charging Gun
Charging equipment shall be located at the
position with rain facilities such as rain
shelter.
Charging equipment shall be located at the
position without deep ponding.
Charging equipment shall not be located at
the position with heavy dust.
Basic Conditions for Use of
Charging Plug
1. Basic conditions for choosing charging
gun holder:
Choose the charging gun with national
standard certification; and
Choose the charging gun with a
temperature sensor.
2. Basic conditions for choosing charger:
Choose a charger equipped with two or
more charging guns. The charger should be
programmed so that the charging gun can
be used alternately.
Choose the charger controlled by
temperature sensor and which has the
function of power off by high-temperature
alarm control.
3. Basic conditions for operating charger:
When charging, choose the one with lower
temperature for charging;
When charging, choose the clean one with
for charging; and
When charging, conform to other
requirements in instructions.
Charging Preparation Stage
Observe the charging gun, charging gun
holder insulator, pin and jack to make sure
that there is no foreign matter.
Warning

If any unknown foreign matter is
found in the charging gun, charging gun
hold insulator, pin and jack, immediately
report to the equipment safety officer and
clean it according to the instructions under
his guidance. If it cannot be cleaned, the
charging process shall be immediately
terminated and relevant after-sales
technicians shall be notified.
Charging Stage
1. Press the "UNLOCK" button on the
charging wall to remove the dust cover of
the charging gun, or get the charging gun
from the charging gun holder.
2.
Hold the charging gun handle with
one hand, hold the lower end of the
charging gun with the other hand, and drag
the charging gun to the vehicle to be
charged.
3.
Keep the charging gun facing the