Dexter Power CSJ18LD, Руководство пользователя

Страница: 14 / 36

14
EN
- REMOVING THE SAW BLADE
To remove a blade, hold the blade and rotate the blade holder ring counter-clockwise to release.
WARNING: The blade may be spring ejected so protect your eyes.
NOTE: When using JIGSAW MODE, the blade teeth face forward as shown in Fig. H.
WARNING: Always wear eye protection while operating this or any other similar power tool.
WARNING: BURN HAZARD. Do not touch the blade immediately after use. Contact with the
blade may result in personal injury.
Before you begin work, ensure the material to be cut is rigid. Small workpieces should be securely
clamped to a work table.
1. SWITCHING ON AND OFF (SEE FIG. I)
For starting operation of the machine, actuate the lock-off button (2) first, then press and hold the
On/Off switch (1) afterwards. To switch off the machine, release the On/Off switch (1).
For safety reasons, the On/Off switch(1) of the machine cannot be locked; it must remain pressed
during the entire operation.
2. HAND GRIP AREAS(3)
Always ensure you maintain a firm grip while operating your jigsaw.
3. PROTECTION FINGER
The protection finger (6) is located in front of the blade holder (7). While working, it will help prevent
accidental contact with the moving blade.
4. LED WORK LIGHT (SEE FIG. G1)
The LED light (12) is built-in near the end of the protection finger. The light will automatically come
on each time when the on/off switch is depressed.
5. CUTTING
WARNING: Always wear eye protection while operating this power tool.
WARNING:
• Never hold the pivot head when operating the tool.
Before cutting any type of material, be sure it is firmly anchored or clamped to prevent slipping.
Holding the work by hand or against your body leaves it unstable and may lead to loss of control.
• Place blade lightly against work to be cut, depress the trigger switch and allow it to obtain
maximum speed before applying pressure.
• Whenever possible, the saw foot plate(9) must be held firmly against the material being cut. This
will prevent the saw from jumping or vibrating and minimize blade breakage.
Any cut which puts pressure on the blade, such as angle or scroll cuts, increases potential for
vibration, kickback and blade breakage.
WARNING: Shock hazard. Use extra caution when cutting overhead and pay particular
attention to overhead wires which may be hidden from view.
WARNING: Use extra caution when cutting overhead and anticipate the path of falling
branches and debris ahead of time.