DEWESOFT DS-CAL, Руководство пользователя программного обеспечения

Страница: 49 / 67

DS-CAL
SOFTWARE USER MANUAL
Krypton RTD channels connect to the DS-CAL test board via a L0B6m-to-DSBU15 cable to the
appropriate ​MULTI (DSUB15 connector) channel​ of the DS-CAL test board. All channels must be
connected and calibrated at once.
Example of connecting the Krypton 8xRTD channels to the DS-CAL test board shows Illustration 37,
page 62.
9.7. DSI adapters
Important
For the calibration of DSI adapter UUT an accessory package DSI CAL SET is required (see
chapter DSI-CAL-SET)!
Additionally, a SIRIUS or DEWE43 instrument is also required (preferred is isolated SIRIUSi
8xSTG)!
Start by connecting the DSI CAL ADAPTER and DSI EXC BNC together via BNC-to-BNC cable as shown
on the Illustration 38, page 63. Connect also a SIRIUS or DEWE43 (see chapter Sirius USB or DEWE43,,
respectively) but without connecting any modules to the DS CAL test board.
Illustration 38: DSI connection cable
Steps to connect the DSI adapter UUT are as follows:
●
DSI CAL ADAPTER connects to the one of eight ​module (DSUB9 connector) channels​ on SIRIUS
or DEWE-43.
●
The other end of the cable with DSI EXC BNC adapter connects to the appropriate DS-CAL test
board’s ​DW 43/STG (DSUB9 connector) channel​.
● On top of the DSI CAL ADAPTER connects a DSI adapter UUT.
●
Connection between the DSI adapter UUT and the DS-CAL test board depends of the type of the
DSI adapter UUT. DSI adapter UUT input connects according to the following chapters.
To calibrate a DSI adapter UUT select DSI tab in the DSCalibrator software as shown on the Illustration
39, page 64. Connected DSI adapter UUTs are detected when mode is changed to DSI. Clicking on the
Refresh button re-detects and re-reads the information about the connected DSI adapter UUTs.
DS-CAL V20-1 49/67