DEWESOFT DS-CAL, Руководство пользователя программного обеспечения

Страница: 45 / 67

DS-CAL
SOFTWARE USER MANUAL
CAN Y-cable.
CAN2 Connects to the DS-CAL test board via a CAN2 connector of the
CAN Y-cable.
AI (DSUB9), channels 1-8 Connects to the appropriate DS-CAL test board’s DW-43/STG
(DSUB9 connector) channels.
CNT (LEMO7), channels 1-8 Connects to the appropriate DS-CAL test board’s counter (CNT
connector) channels.
Table 17: DEWE43 UUT connection description
9.6. Krypton
Important
For connecting the Krypton UUT to the PC via a network connection a dedicated network
device must be used! It is not allowed to connect it via a network switch, hub or a router!
Therefore, a PC with two network devices is required if at least one network device is used to
connect the PC to the internet (or intranet).
Important
If you are using the DS-CAL1 v1 or DS-CAL1 v3 test board, you must use and connect DS-CAN2
along with the UUT (see 8.5.3 Dewesoft UUT without CAN port, page 43)!
Important
Unless otherwise noted, the channel 1 on the UUT connects to the channel 1 on the DS-CAL test
board and so on for up to all eight UUT channels, respectively.
Krypton UUT requires a power cable (8-pin LEMO) and a network connection to the PC connected.
Connect the Krypton UUT as described by the Table 18.
Krypton UUT Connection
IN Ethernet connection to the PC.
OUT Power supply for the UUT.
Table 18: Krypton UUT connection description
The next step is to connect all the channels of the Krypton UUT, which is described in the following
chapters.
DS-CAL V20-1 45/67