Dewert User Manual Model 2410XL - Updated 05.2021/1 MDR Page 4 of 12
1.8 Model designation and type labelling
The exact model designation depends on the choice of frame colour:
-00 white powder coated (RAL 9010);
-03 white aluminium powder coated (RAL 9006);
-04 grey aluminium powder coated (RAL 9007)
The type plate is attached to the underframe on one long side of the table. It provides information about key
table data.
The following symbols are listed there (by way of example), their meanings are:
Read the operating
manual
Serial no.
Applied part Type B
Caution, potential
hazard
Max. load
capacity
CE mark
Date of manufacture
Product may only
be used in dry
rooms
Do not dispose of with
household waste
Address of
manufacturer
Protective
insulation,
protection class II
1.9 Meaning of the serial number
The serial no. is located on the type plate or shown separately next to the type plate of the table. This number
is unique and firmly linked to this specific individual product. It enables us to identify this table model and
trace back assemblies/safety-relevant components at any time.
Please always state this serial number when enquiring about spare parts.
2. Operating manual
2.1 Table design
When designing the table frames, special emphasis was placed on functional and operational safety. The
number of possible pinching points has thus been minimised, while remaining ones have been covered or
protected with spacers to prevent injury, thus ensuring safe and yet simple operation. Nevertheless,
necessary caution must always be exercised when using the table.
The table consists of the following assemblies: - underframe, - scissor section, - upper frame, - upholstery.
Depending on the respective version, these assemblies can feature further attachment parts. The surfaces of
the welded design are plastic coated. The hydraulic system for height adjustment is located between the
scissor section and the underframe, which guarantees very high power transmission even in the lowest
adjustment range (min. height). Operating the lateral pedal causes the lifting tube of the hydraulic system to
extend or retract. The scissors are thus pushed apart or together, thus enabling adjustment of the lying
surface.
2.2 Height adjustment
Height adjustment
The height is adjusted by repeatedly depressing (pumping) the foot lever on one side of the table. To lower
the table, the foot lever is simply lifted with your foot.
If the table is only lifted slightly each time the foot lever is depressed after transport or a longer period of non-
use, air bubbles have formed in the hydraulic system. To remove the air bubbles, pump the table upwards
under load and perform an additional 20 - 30 strokes of the pump when the table is in the uppermost position.
This will force air out of the system.
