20
English
WARNING:
Use of this tool can generate and/or disburse dust,
which may cause serious and permanent respiratory or other injury.
Always use NIOSH/OSHA approved respiratory protection appropriate
for the dust exposure. Direct particles away from face and body.
WARNING:
ALWAYS
USE SAFETY GLASSES. Everyday
eyeglasses are NOT safety glasses. Also use face or dust mask if
cutting operation is dusty. ALL USERS AND BYSTANDERS MUST
ALWAYS WEAR CERTIFIED SAFETY EQUIPMENT:
• ANSI Z87.1 eye protection (CAN/CSA Z94.3),
• ANSI S12.6 (S3.19) hearing protection,
• NIOSH/OSHA/MSHA respiratory protection.
• The label on your tool may include the following symbols. The
symbols and their definitions are as follows:
V ................... volts
A ......................amperes
Hz ................. hertz
W .....................watts
min ............... minutes
or AC ..........alternating
or DC ... direct current
current
................. Class I Construction
or AC/DC ...alternating
..................... (grounded)
........................
or direct
................. Class II Construction
current
(double insulated)
no ....................no load
…/min .......... revolutions per minute ....................... speed
BPM ............. beats per minute n
......................rated
IPM ............... impacts per minute
........................
speed
SPM ............. strokes per minute
.....................earthing
sfpm ............. surface feet
terminal
.....................
per minute
.....................safety alert
.....................
symbol
ASSEMBLY AND ADJUSTMENTS
WARNING: To reduce the risk of injury, turn unit off and
disconnect tool from power source before installing and
removing accessories, before making any adjustments or
removing/installing attachments or accessories.
An accidental
start-up can cause injury.
WARNING:
Prior to assembly and adjustment, always unplug tool.
Spade Handle Assembly (Fig. 1)
This spade handle can be attached either
FIG. 1
horizontally or vertically. Place the handle into
the locating boss on the back of the drill and
assemble with holding knob.
Side Handle (Fig. 1)
WARNING:
To reduce the risk of personal
injury,
ALWAYS
operate the tool with the side
handle properly installed. Failure to do so may
result in the side handle slipping during tool operation and subsequent
loss of control. Hold tool with both hands to maximize control.
The side handle can be placed in either side of the drill or the top
of the drill according to operator preference and available working
clearance. The spade handle can be temporarily removed if working
clearance at rear of tool is limited. Always replace spade handle when
possible.
Switch (Fig. 2)
To start the drill, depress the trigger switch (A); to stop the drill, release
the trigger.
A variable speed trigger switch permits speed control—the farther the
trigger is depressed, the higher the speed of the drill.
NOTE:
Use lower speeds for starting holes without a center punch,
drilling in metal or plastics, driving screws or drilling ceramics. Higher
speeds are better for drilling wood and composition boards and using
abrasive and polishing accessories.
