DeWalt DCD985-XE, Инструкция по эксплуатации

Страница: 9 / 16

7
c. Move the charger and battery pack to a location where the surrounding air
temperature is approximately 18° – 24°C (65°F and 75°F);
d. If charging problems persist, take the tool, battery pack and charger to your
local service center.
5. The battery pack should be recharged when it fails to produce sufficient power
on jobs which were easily done previously. DO NOT CONTINUE to use under
these conditions. Follow the charging procedure. You may also charge a partially
used pack whenever you desire with no adverse effect on the battery pack.
6. Foreign materials of a conductive nature such as, but not limited to, grinding dust,
metal chips, steel wool, aluminum foil, or any buildup of metallic particles should
be kept away from charger cavities. Always unplug the charger from the power
supply when there is no battery pack in the cavity. Unplug the charger before
attempting to clean.
7. Do not freeze or immerse the charger in water or any other liquid.
WARNING: Shock hazard. Don’t allow any liquid to get inside the charger. Electric
shock may result.
WARNING: Burn hazard. Do not submerge the battery pack in any liquid or allow
any liquid to enter the battery pack. Never attempt to open the battery pack for any
reason. If the plastic housing of the battery pack breaks or cracks, return to a service
center for recycling.
Storage Recommendations
1. The best storage place is one that is cool and dry, away from direct sunlight and
excess heat or cold.
2. For long storage, it is recommended to store a fully charged battery pack in a
cool dry place out of the charger for optimal results.
NOTE: Battery packs should not be stored completely depleted of charge. The battery
pack will need to be recharged before use.
SAVE THESE INSTRUCTIONS FOR FUTURE USE
COMPONENTS (FIG. 2)
WARNING: Never modify the power tool or any part of it. Damage or personal
injury could result.
A. Trigger switch I. Battery pack
B. Forward/reverse control button J. Battery release button
C. Worklight K. Belt hook
D. Chuck L. Mounting screw
E. Torque adjustment collar M. Bit clip
F. Mode control collar
G. Gear shifter
H. Side handle
A
B
E FIG. 2
G
D
I
J
C
F
H
K
M
L
J