10
5. Press the spindle lock button (C) and rotate the spindle (K) until it locks in
position (Fig. 5).
6. Tighten the threaded clamp nut (N) with the two-pin spanner supplied.
7. Release the spindle lock.
8. To remove the disc, loosen the threaded clamp nut (N) with the two-pin spanner.
Fitting a Wire Cup Brush
Screw the wire cup brush directly onto the spindle without the use of the spacer and
threaded flange.
Prior to Operation
• Install the guard and appropriate disc or wheel. Do not use excessively worn
discs or wheels.
• Be sure the inner and outer flange are mounted correctly.
• Make sure the disc or wheel rotates in the direction of the arrows on the
accessory and the tool.
OPERATION
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories.
Before reconnecting the tool, depress and
release the on/off switch to ensure that the tool is off.
WARNING:
Always wear regular working gloves while operating this tool.
WARNING:
The gear case becomes very hot during use.
It is important to choose the correct guards, backing pads and flanges to use with
grinder accessories. Refer to pages 9–10 for information on choosing the correct
accessories.
WARNING:
• Ensure all materials to be ground or cut are secured in place.
• Apply only a gentle pressure to the tool. Do not exert side pressure on the disc.
• Avoid overloading. Should the tool become hot, let it run a few minutes under
no load condition.
FIG. 7
Q
E
115 mm and 125 mm Sanding Flap Discs
Quick-change
backing flange
Non-hubbed sanding flap
disc
Threaded clamp nut
Type 27 guard
Hubbed sanding flap
disc
Type 27 guard
