DeWalt D25961-XE, Инструкция по эксплуатации

Страница: 8 / 12

6
Switching On and Off (Fig. 1)
To turn the tool on, set the on/off switch (A) to position 1. To turn the tool off, set
the on/off switch (A) to position 0.
Demolition, Chasing and Channelling (Fig. 1, 4)
WARNING: Ensure that the cutting edge does not show discoloration caused by
too much pressure. This may impair the hardness of the accessory.
Various types of chisels are available as an option.
1. Select the appropriate chisel. Clean and grease its shank.
2. Insert the chisel and check whether it is properly locked.
3. Fit and adjust the side handle (F) and ensure side handle is secure and does
not rotate.
4. Hold the tool at both handles (B, F) and switch on. The tool now runs in
continuous operation.
5. Always switch off the tool when work is finished and before unplugging.
FIG. 4A B
F
FIG. 4B
B
MAINTENANCE
WARNING: To reduce the risk of serious personal injury, turn tool off and
disconnect tool from power source before making any adjustments or removing/
installing attachments or accessories. An accidental start-up can cause injury.
Lubrication
Your power tool requires no additional lubrication.
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air at least
once a week. To minimize the risk of eye injury, always wear AS/NZS51337
approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for cleaning the
non-metallic parts of the tool. These chemicals may weaken the plastic materials
used in these parts. Use a cloth dampened only with water and mild soap. Never
let any liquid get inside the tool; never immerse any part of the tool into a liquid.
Repairs
This machine is not user-serviceable. Take the tool to an authorized D
E
WALT repair
agent after approximately 100 hours of use. If problems occur before this time
contact an authorized D
E
WALT repair agent.
To assure product SAFETY and RELIABILITY, repairs, maintenance and adjustment
(including brush inspection and replacement) should be performed by certified
service centers or other qualified service organizations, always using identical
replacement parts.
ACCESSORIES
WARNING: Since accessories, other than those offered by D
E
WALT, have not
been tested with this product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only D
E
WALT recommended accessories
should be used with this product.
These chisels can be reground only a limited number of times. Contact your dealer
for recommendations.
Recommended accessories for use with your tool are available at extra cost from
your local service center. If you need any assistance in locating any accessory,
please contact Stanley Black & Decker, 82 Taryn Drive, Epping, VIC 3076 Australia
or call 1800 444 224 or (NZ) 0800 339 258.