Use of the speaker
This speaker is designed to perform in professional environments. Speech, music, or any other type of sound
can be played trough this speaker.
For optimal performance, a suitable PA-amplifier is needed. Each Artis passive speaker has its own
characteristics, based on the internal components. For every Artis passive speaker, there is a maximum
power handling, optimized for the woofer and tweeter.
Devine advises to use a PA-amplifier which is able to provide about 1.5x more power than the RMS power
handling of your speakers. The RMS values are measured with a static sinus and not with dynamic music,
therefore it is safe to use this configuration. As the Artis passive speakers have a larger maximum peak
power handling, they are capable of handling short peak power values.
This configuration is also beneficial for your PA-amplifier, as it does not have to work at full power to provide
your speakers with optimal power. Make sure though that you do not exceed the maximum capability of your
speakers, which occurs when you hear distorted sounds or when the CLIP LEDs on your amplifier are lit.
It is possible to connect another Artis passive speaker to the second output of your first Artis passive
speaker. However, take notice that the impedance of your speaker system drops to 4 Ohm. Make sure your
PA-amplifier is suitable for this impedance or contact your local dealer if you have any doubts, as wrong
impedances might damage your speaker system permanently.
Use proper cable and proper connectors to connect your speakers and amplifier. Devine recommends to use
prefabricated speakercables with pre-mounted connectors.
Devine also recommends the use of the lockable speaker connectors, for optimal reliability.
When making your own speaker cables, only use good quality speaker cable with at least a 2x 1.5mm² core.
Thin wiring and high power may result in melting cables!
Use your ears to make sure you don’t blow up your speakers or cause any other damage to its internal
components. When you hear any distortion or when your PA-amplifier is clipping, you need to decrease the
volume on your mixer or amplifier.
All Artis passive series speakers are equipped with a 35mm stand adapter, which makes it possible to place
the speaker on a suitable height. This makes the distribution of high and mid-frequencies easier. See the
image for details. 35mm is a standard size for speaker stands, so most speaker stands will fit the speaker
properly.
Warranty is void when damage to this speaker is caused by improper use. When any damage to this speaker
occurs, please contact your local dealer for help.
Any information and illustrations shown in this user manual are subject to change without further notice.
User manual version: 3.0
Creation date + author initials: 04-12-2013 RV Revision date + author initials: 29-03-2014 RV
