DeVillbiss Air Power Company AFN5, Инструкция по эксплуатации, техническому обслуживанию и запасным частям

Страница: 7 / 16

7
Many air tool users find it convenient to use a Filter to
remove liquid and solid impurities which can rust or
"gum up" internal parts of the tool. A
Filter also
increases the efficiency and useful life of the tool.
Drain water from the filter periodically.
(See Figure 3)
Do not store the tool in cold weather. Frost or ice can
form on the operating valves or mechanisms and the
tool may not operate correctly.
Figure 1
Figure 2
Figure 3
In cold weather operation (near or below freezing), DO
NOT USE a permanent antifreeze such as ethylene
glycol for a cold weather lubricant. This type of anitfreeze
will damage o-rings and seals of the tool.
NOTE
Many air tool users find it convenient to use an Oiler
to help provide oil circulation through tool. An Oiler
also increases the efficiency and useful life of the tool.
An oiler is recommended for tools that receive heavy
or constant use. Check oil level in the oiler daily.
(See Figure 2)
LUBRICATION AND MAINTENANCE
NOTE
Proper lubrication is the owner's responsibility.
Failure to lubricate the tool properly will dramatically
shorten the life of the tool and void your warranty.
NOTE
Excessive oil will damage o-rings and seal of
tool. If in-line oiler is used, manual lubrica-
tion through the air inlet is not required on a
daily basis.
Regulator
Oiler
Regulator
Filter
1. Disconnect the air supply from the tool before
manually lubricating.
2. Turn the tool so the air inlet is facing up and put one
drop of Air Tool Oil, high speed spindle oil, such as
Unocal RX22, or 3-in-1 oil into the air inlet. DO NOT
USE detergent oil or additives. Operate the tool
briefly after adding oil.
(See Figure 1)
DO NOT OVER LUBRICATE AIR TOOL.
3. Wipe off excessive oil at the exhaust.
Your tool requires lubrication before you use it for
the first time and before and after each additional
use.
If an Oiler is used, manual lubrication through the
air inlet is not required on a daily basis. Lubrication
prevents wear and prevents rust from forming.