D
e
V
ilbiss
I
ntelliPAP
S
eries: Single Battery
C
onnection
BATTERY POWER SOLUTIONS
Page 1 of 2 February 2017
DeVilbiss IntelliPAP series devices can be connected directly to the
Freedom
TM
CPAP Battery using the DC power
pigtail cord and appropriate connector tip included in the Freedom
TM
CPAP Battery Kit. Please note IntelliPAP 2 series
devices will require the use of the 150W sine wave power inverter in conjunction with the Freedom
TM
CPAP Battery
Kit to complete the connection between the PAP device and the battery.
REQUIRED COMPONENTS
Freedom
TM
CPAP Battery Kit
CONNECTION INSTRUCTIONS
Plug the DC power pigtail cord into the DC OUT jack of the battery.
Insert the connector tip with blue top labeled “J” into the DC power pigtail cord.
Plug the DC power pigtail cord with “J” connector tip attached into the DC input port of the PAP device.
Turn the PAP device on and it should begin functioning.
The digital display screen will show the charge level of the battery. You may press the charge level indicator
button to illuminate this screen. It will stay illuminated for a few seconds at a time.
When not in use disconnect all devices from the battery thus allowing the battery to completely shut down.
CONNECTOR TIP INSERTED
INTO PAP DC INPUT PORT
DC POWER PIGTAIL CORD
DC OUT JACK
OPTIONAL FREEDOM
TM
CPAP BATTERY CHARGING ACCESSORIES
Auto Charge DC Cable {BPS DC.CABLE}: Used to charge the battery in a vehicle (vehicle must be running).
150W Sine Wave Power Inverter {BPS 150 INVERTER}: Used to charge the battery in a vehicle (vehicle does not need to
be running) and allows the battery to power/charge other small electronic devices.
SunPower 40W Solar Panel {BPS SP40}: Used to charge the battery using the power of the sun.
