Devatec ElectroVap KIT MC 15, Инструкция по эксплуатации, Страница: 13 / 48

ELECTROVAP® KIT MC
13
INSTALLATION
3.1 PROCEDURE
•
Remove the device from its original packaging and check its condition. If there is any defect in the
appliance, make a detailed complaint to the carrier within 3 days.
•
Remove the steam cylinder and place it carefully on the floor.
Step 1
•
Take the drilling template provided, and place it in the desired
location, taking into account the dimensions.
•
Mark and drill the mounting locations:
KIT MC 5 to 30: mark the 8 holes.
KIT MC 40 to 60: mark the first 8 holes. Mark the corners
of the template and then place the template on the right
side. Align the corners and mark the last 8 holes (16
markings in total).
•
Then drill a hole of Ø3 or 4 mm according to the diameter of
the fixing screws you want to use.
Step 2
•
Take the upper support. Screw in the first screw (for
example), make sure that the support is level (use a spirit
level) and then screw in the 4 screws until they are locked.
•
Attention: for the KIT MC 40 to 60, do not forget to fix the 2
high supports (8 fixing screws in total).
Step 3
•
Take the lower support. Screw in the screws and check the
vertical alignment and your dimension H (see dimensions on
pages n°9 & 10 & 11) and then screw in the 4 screws until they
are locked.
•
Caution: for the KIT MC 40 to 60, do not forget to fix the 2
lower supports (8 fixing screws in total).
1
H