DEV 5072, Руководство пользователя

Страница: 50 / 71

User Manual DEV 5072
50

Copyright DEV Systemtechnik GmbH 2016-2017
5.5.4.1 .devPowerTraps
Aside from the SNMP standard trap 'Cold Start Trap', this MIB additionally supports
three specific traps.
Note:

By default, all traps are disabled.
By setting the corresponding bit in the .trapEnableMask (please refer to
chapter 5.5.4.4.1) each trap can be enabled individually.

Traps for specific error classes can be masked out by clearing the appropriate
bits in the .errorEnableMask (chapter 5.5.4.4.2).
5.5.4.1.1 .devPowerTraps.trapAlarmText
This trap (number 3, OID: .1.3.6.1.4.1.21035.34.0.3) is triggered if the device
detects a new error. It delivers the appropriate error message (please refer to
chapter 6.1) obtained via .errorDescription (chapter 5.5.4.4.5).
To enable the trap, bit 6 (enum: errortext) in the .trapEnableMask is to be set.
5.5.4.1.2 .devPowerTraps.trapAlarm
This trap (number 4, OID: .1.3.6.1.4.1.21035.34.0.4) is triggered if the device either
detects a new error or if a pending error disappears. The trap delivers .errorNr
(please refer to chapter 5.5.4.4.4.2) and .errorPending (chapter 5.5.4.4.4.5) for the
corresponding entry in the .errorTable.
Bit 5 (enum: error) in the .trapEnableMask is to be set to enable the trap.
5.5.4.1.3 .devPowerTraps.trapModeChange
This trap (number 5, OID: .1.3.6.1.4.1.21035.34.0.5) is triggered if the device
detects that an operation mode change was performed. The trap delivers
.controlMode (please refer to chapter 5.5.4.3.1).
To enable the trap, bit 4 (enum: modechange) in the .trapEnableMask is to be set.