DEV 5072, Руководство пользователя

Страница: 18 / 71

User Manual DEV 5072
18

Copyright DEV Systemtechnik GmbH 2016-2017
If the device is to be connected to the local network, make sure to change the
network setup as required. Ask your network administrator for the details on
network parameters which are to be used.
The factory network settings are subject of chapter 4.3.2.
There are implemented two different methods to change the network setup; either
via Web Interface (please refer to chapter 5.4.6.2.1) or via the serial interface as
described in the following chapter.
4.4.2.2 Network Setup via the Serial Interface
Note that in combination with the DEV 5101 the connection for the network setup
via the serial interface is realized differently; please refer to the DEV 5101 user
manual.
To change a few elementary parameters of the network setup via the serial
interface for a standalone DEV 5072, establish a hardware connection between a
RS 232 port of a PC (e.g. COM1) and the DEV 5072 serial interface using a straight
cable; please refer to chapter 7 for the pin assignment of the serial connector.
Next, start a terminal application (e.g. MS Windows HyperTerminal) on your PC.
Note:

The interface settings of the terminal application have to match the serial
interface configuration (chapter 4.4.1); otherwise, it is not possible to enter the
configuration program as described below.

The terminal application is to be configured that the "Backspace" or "←" key on
the keyboard works properly in the application, and that it sends a
<CR>
only
(and not a
<CR><LF>
) when hitting the "
Enter
" or the "

" key on the keyboard.
If using MS Windows HyperTerminal, select the "Properties" entry from the
"File" menu and click on the "Settings" tab. There select "ANSI" from the
"Emulation:" drop down list and then click on the
button to
uncheck "Send line ends with line feeds" as shown in the following figure: