DETEWE opencom 100, Руководство по монтажу и пусконаладке

Страница: 21 / 136

19
Installation Available Ports
■
Four U
pn
ports, designed as
pressure terminals (U
pn
1 to
U
pn
4)
■
One LAN port (10BaseT), de-
signed as an RJ45 socket
■
One COM port for connection to
a PC for configuration or transfer
of call data, designed as an RJ45
socket
■
One port jack to connect the
plug-in power supply. Only use
the original OpenCom 107 plug-
in power supply.
CAUTION! It is not allowed
to operate the plug-in power sup-
ply inside the housing of the
OpenCom 107.
OpenCom 105
■
Four analogue a/b ports, de-
signed as pressure terminals (a/
b1 to a/b4)
■
Two actor ports for connection
to a door opener and entrance
intercom system, designed as
pressure terminals (Actor1 for
activating a door opener and
Actor2 for activating an en-
trance intercom)
■
One sensor port for connection
to the bell of an entrance inter-
com system, designed as a pres-
sure terminal (sensor)
■
One PCM port for the connection
of two systems, designed as an
RJ45 socket (PCM)
■
One S
0
port for connection to an
external S
0
bus (usually the
NTBA), designed as an RJ45
socket (S
0
1)
■
Two switchable S
0
ports (S
0
2
and S
0
3), which can be con-
nected to either an internal or
an external S
0
bus. The internal
port is designed as a pressure
terminal, the external port as an
RJ45 socket
■
One S
0
port for an internal S
0
bus, designed as a pressure ter-
minal (S
0
4). S
0
4 can also be
wired externally (as a master)
when networking two
OpenCom 100 communications
systems in a Q.SIG trunk (also re-
fer to
PBX Networking starting
on page 73).
■
Four U
pn
ports, designed as
pressure terminals (U
pn
1 to
U
pn
4)
■
One LAN port (10BaseT), de-
signed as an RJ45 socket
■
One COM port for connection to
a PC for configuration or transfer
of call data, designed as an RJ45
socket