Detcon SmartWireless CXT, Руководство по установке и инструкции оператора

Страница: 27 / 55

Se nti nel C X T
Sentinel CXT Instruction Manual Rev. 1.7 Page 21 of 49
4.R e cha rgi ng the Inte rnal B a tte ry P a ck
4.1 N on-H a z a rdous a nd Indoor L oca ti on
At a safe time interval prior to full discharge of the internal battery pack, relocate the CXT Controller to a
non-hazardous indoor location area that has suitable 110 VAC or 220 VAC AC power receptacles
available.
4.2 C onnecti ng toM a i ns Supply
Connect the battery charger connector to the external port labeled external power. Using the appropriate
Battery Charging Accessory product (PN
976-0003BC-00T
for 110 VAC or PN
976-0003BC-220
for 220
VAC), find the corresponding Mains Supply receptacle in an indoor non-hazardous area and plug-in the
pronged end of the cable. Operate the charger for the necessary time it takes to accomplish a full charge.
CAUTION
Only the Mains supply cord that is supplied with the Detcon-approved Battery
Charger Accessory product shall be used. Use of any other Mains supply cords will
impair the safety of this device.
Warning
Charging of the internal Battery Pack shall never be done while equipment is
located in the Division 2 hazardous area. The equipment must be moved to a non-
hazardous indoor location area for the battery charging to take place.
The
temperature during the indoor battery charging shall be between 0-40C.
Warning
The charging power supply is only safely rated for indoor use, so use of the Detcon
charging accessory is limited to indoor non-hazardous areas.
5.Syste m C onfi gura ti on
5.1 Syste m O pe ra ti on
The setup of the controller is critical for proper operation. Modbus
™
addresses must be correct on all the
devices connected to the controller before the controller will acknowledge the devices. Each wireless
sensor must have a unique Modbus address (refer to sensor manual for details).
5.2 O pe ra tor Inte rfa ce
5.2.1 M a gneti c P rogra m m i ng T ool
The magnetic programming tool (Figure 20) is used to operate the magnetic switches. For switch
activation, the programming magnet is briefly held on the switch marker (

) and then removed. This action
will be referred to as a "swipe" for the remainder of this manual.