EN
Operation
12/2020
9 / 16
The counter of the number of drillings done with the current cutting tool is displayed.
You can reset this counter by clicking
Reset counter
.
In the box
Cycle counter limit
, enter the number of drilling cycles (from 0 to 1,000,000) at which the tool will be
stopped.
Tick
Lock tool
.
Click this button to update the tool.
How to set up speeds
Tools are equipped with a double-step trigger which allows to adjust the drilling speed to the material.
Connect the tool to XPB Config.
Click this button to read the tool.
Go to the tab
Head and Psets configuration
.
There are 4 steps in a drilling cycle.
Speeds by default are given in chapter
Start-up
This step is at the start of the drilling cycle whatever the trigger position.
Enter the rise time (min. 100 ms / max. 5000 ms / 200 ms by default).
Enter the tool speed.
Enter the step duration (0 ms by default, 5000 ms max.).
S1
S1 stands for Speed 1.
This step gives the acceleration time and the speed when the trigger is pressed halfway.
Enter the rise time (min. 100 ms / max. 5000 ms / 200 ms by default).
Enter the tool speed.
S2
S2 stands for Speed 2.
This step gives the acceleration time and the speed when the trigger is fully pressed.
Enter the rise time (min. 100 ms / max. 5000 ms / 200 ms by default).
Enter the tool speed.
Final
This step controls the speed decreasing at the end of the drilling cycle, when the trigger is released.
Enter the rise time (min. 100 ms / max. 300 ms / 100 ms by default)
