79 Trenton Avenue, Frenchtown NJ 08825
© Copyright 2018 Designplan Lighting, Inc.
installation instructions
P: 908-996-7710
F:
908-996-7042
1 of
5
INSTRUCTIONS PERTAINING TO RISK OF FIRE OR INJURY TO
PERSONS. READ ALL INSTRUCTIONS. IMPORTANT SAFETY
INSTRUCTIONS. SAVE THESE INSTRUCTIONS.
STEP OUTSIDE
5.1, 5.2, 6.1, 6.2,
6.3
IP
65
5.X
6.X
Electrical Connections:
• LED lights must be
connected in series
respecting polarities.
•
CHOOSE POWER SUPPLY ACCORDINGLY
. Please consider the voltage through which fixtures are fed
as well as the max power consumption.
•
Connect power
only if all fixtures are connected.
• The power supplies MUST be installed in aerated rooms, far from heat sources. Overworking or lack of air
circulation will not permit natural dissipation.
• The electronic power supply is current-stable, therefore it partially compensates the voltage-drop problems
related to the cable length; we suggest not to exceed 100
ft.
• Use only Class 2 type electronic power supply.
• Never use switches on secondary circuit.
Maintenance
Scheduled maintenance must be carried out once a year on all lighting devices, regardless of appliance
class and type of use. It must include the following operations:
• Periodically clean fixtures to remove dirt from gratings and screw heads.
• Check tightness of screws on various parts of the device.
• Check that all cable glands and cables are intact and tight. Check that the glass or plastic
lens
is
intact,
and replace it if broken or damaged.
• The internal components such as the ballast,
driver,
washers and screws must not show clear
signs
of
oxidation or rust. Clear traces of rust and oxidation will indicate the presence of water inside
the
device.
• In the case of damage, the components must be replaced by original components or spare parts.
DANGER - RISK OF SHOCK - DISCONNECT POWER BEFORE
INSTALLATION! Please read all instructions before installation.
• Keep these instructions for future reference.
• Must be installed by a qualified electrician in accordance with national and
local standards. Designplan is not responsible for fixtures installed without
regard to these standards.
•
The main power connection must be in accordance with local electrical
codes.
• Unauthorized alterations or tampering of product voids warranty.
• Suitable for
OUT
DOOR applications.
Remote 500mA
ATTENTION
:
For Wall/Ceiling -
It is the contractor's responsibility to caulk around all the edges between
the fixture and the mounting surface to satisfy wet label requirements.
TM
