+DES IGN
Pag. 1 - rev.00
NOTES:
•
Wire connections must be realized with wire nuts or
similar.
.....
1.063"
.98"
2.28"
Ø
1.18" X 1.61"
SPOT 1.0
w/ AQUASTOP
Installation instructions
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
WARNING!!!
Please read the following instructions carefully.
IMPORTANT:
•
Although LED runs on a very low voltage, always cut off the power sup-
ply before installing the LED light or subjecting it to maintenance.
•
Unauthorised alterations or tampering of the product will invalidate all
the conditions of guarantee.
•
This fixture must be installed by a qualified electrician.
•
Designplan is not responsible if its fixtures are not installed in
according to local safety standards.
•
Data contained in this document may be changed at any moment with-
out prior notice.
•
Use only Selv type electronic power supply or similar.
ELECTRICAL CONNECTIONS:
•
LED lights run at constant current.
•
LED lights must be
connected in series
respecting polarities.
•
As for the choice of the power supplies, please consider the current
through which they are fed and the max power consumption of
LEDs you have to install.
•
The total number of LEDs to be fed must be counted for each single
spot (e.g. 2 spots with 3 LEDs 1W each= 6 LEDs 1W in all= 6W).
•
The system must be fed only if all the spots are connected.
The
connection of the single spots with the power supply in voltage may
damage
the spot.
•
The power supplies must be installed in aerated rooms, far from heat
sources. A situation of overworking or a lack of air circulation will not
permit a natural dissipation.
•
The electronic power supply is current-stable, therefore it partially com-
pensates the voltage-drop problems related to the cable length; we
suggest not to
exceed
120ft
(
30 metres
)
.
•
Never use switches on secondary circuit.
Designplan Lighting, Inc., 79 Trenton Ave., Frenchtown NJ, 08825. T.908-996-7710 F.908-996-7042
2.16" - 3.07"
