SINGLE HANDLE KITCHEN FAUCET
4-8-16
Design House is a registered brand
of DHI Corp.Mequon,WI 53092
1-800-558-8700
PREPARATION
SAFETY INFORMATION
Before beginning assembly of product, make sure all parts are present.
Compare parts with package contents list and hardware contents. If any
part is missing or damaged, do not attempt to assemble the product.
Contact customer service for replacement parts.
Estimated Assembly Time: 30 minutes
Tools Required for Assembly (not included): Adjustable Wrench, Groove
Joint Pliers, Pipe Wrench, Phillips Head Screwdriver, and Supply Lines.
Installations may vary depending on how the previous faucet was
installed. Supplies necessary for the installation of the faucet are not
all included; however, they are available wherever plumbing supplies
are sold.
Prior to beginning installation, turn off the hot and cold water lines,then
turn on the old faucet to release built-up pressure. When installing the
new faucet, hand tighten the connector nuts.
DO NOT OVERTIGHTEN.
Connections that are too tight will reduce the integrity of the system.
Please read and understand this entire manual before attempting to
assemble, operate or install the product.
WARNING
•
Protect your eyes with safety glasses when cutting or soldering water
supply lines.
CAUTION
•
If you solder the joints during installation of the faucet, the seats,
or the warranty will be voided on these parts.
•
Cover the sink drain to avoid losing parts.
PRODUCT SPECIFICATIONS
SPECIFICATIONS
SPECIFICATIONS
Ceramic cartridges
ASME A112.18.1/CSA B125
Manufactured to include no more than 0.25% weighted average lead
content on wetted surfaces
ANSI/NSF 61-9
1 or 3-hole installation - optional deck plate and side spray not included
MODELS
547695-Polished chrome
547737-Brush nickel
547620-Polished chrome
547638-Satined nickel
www.todaysdesignhouse.com
Polished chrome and Satined nickel finish
NSF/ANSI 372
Notes: The picture in this installation instructions is for reference
only, pls refer to actual product in installation process.
2
www.todaysdesignhouse.com
1. Turn off water under sink.
Remove old faucet making sure
not to damage water lines.
1
Insert spray hose down through
hole in spray holder. Attach
lower end of spray hose to
entral supply tube in faucet.
5
2. Install the spout through top of
sink. From underneath the sink,
replace the rubber seal, metal
washer and lock nut. Tighten the
screws on the lock nut to secure
the body.
2
6. Tighten end of shank with
wrench and slip coupling nut
onto inlet port.
6
3. Insert optional spray holder
through the hole in sink.Screw
lock nut to shank and tighten.
3
7. After installing faucet, remove
aerator and turn on water to
remove any debris.
Re-assemble aerator.
ASSEMBLY INSTRUCTIONS
5.
Screw spray head onto spray
hose.
4
7
4.
